Liesl Gibson

Hi Katie,

The front of the Cappuccino dress is a bit tricky as it’s made up of three pattern pieces.

Do you like the current fit and dress length but want to raise the pockets on the dress?

Or do you want to shorten the whole dress? Then the question becomes where? Through the body or at the hem or both?

Sliding the pockets up the dress…[Read more]

Dawn, all seam allowances are 1/2″ on that pattern.

I haven’t sewn the Marais dress (yet) so take the following with a grain of salt, but here’s what I’d do if I wanted to add a sleeve:

Choose the knit pattern that you like the sleeve/armscye of; eg metro T, or the Easton, or the Belgravia dress, etc

Trace both patterns in your size and find the centre front line (it’s the fold line for the metro…[Read more]

You need to choose a paper or digital pattern from the start. All our digital patterns have a title that begins with the word “digital”. If a pattern title does not begin with the word “digital” it is the paper version.

The digital Fira Dress is found here:

https://oliverands.com/shop/digital-fira-dress-top-sewing-pattern.html

I would do both equally. Remember, even a little bit makes a difference, a 1/4″ off inner and outer will make a full 1″ reduction in circumference.
They’re a relatively slim/straight leg fit anyway. Are you sure you want them narrower? Using a trace and Toile interfacing you can “tissue fit” the pattern. Just sew the one leg pattern pieces front…[Read more]

Oh, I see what you are saying now.

Yes, the center lines should match up on all pieces. The grain lines are just for indication of how to place the pattern piece on your fabric. They don’t need to match up exactly between pieces. As long as they are pointing in the same direction on both pieces (which they do) you’ll be fine.

Hi @lillypilly I use Trace and Toile all the time too.
You know what I often find is I accidentally have a piece of tracing upside down, then the grain lines don’t match!
For that reason I always trace the wording on the pattern piece as well

It could be that the pieces have not been tiled together correctly. Can you upload photos?

It is very roomy @sewrosey61 as it fastens with a side button.
This lovely pattern is my go to as a teacher gift. My last version was sewn for a AUS size 20.
(My tip, attach the button with elastic so it has some ease)
Alternatively, I think you could make a wee tab that has buttons on each end.

Good luck!

Our PDF patterns are a little different than others in that you do not assemble a whole, large pattern sheet with all the pieces on it. Instead, you will be assembling the individual pieces one by one. (Why put them all together in a large sheet only to immediately cut them apart, right?) The tiled pieces do not fit together into a single sheet,…[Read more]

🙂
Sure, but be warned the sewing queue is long! I’ve got three bear suits and a Goldilocks dress to sew for next month’s Melburn-Roobaix

Nice! Can you make me one too????

There are times when the calibration of a printer’s driver is just off by a bit. We’ve seen cases of this happening more than once.

If you want to double check the file vs. what the printer is saying about the size of the test square when printed, you can turn the rulers on in Adobe Reader to measure the size of the square within the software. I…[Read more]

For clarity sake, can you say whether you were printing the A4/letter version, or 36″ wide roll, or A0 standard paper sheets.

If someone tries to fit the US 36″ wide (darn you US rebels) to an international standard A0 sheet the scaling could easily end up whacked.

It’s still available via this page.

https://oliverands.com/shop/digital-woodland-stroll-cape-sewing-pattern.html

thank you. This is exactly what I needed to know. L D cup with slash and spread! THANK YOU!