Site-Wide Activity

Yes, I appreciate the difference between SA vs cut edge, although it’s helpful to know that the expected length difference is 1 inch. I do seem to have a bit too much length in the facing piece but I can make it work.

Thanks so much for your replies!

I can’t see the centre back fold marking on your lining piece, so it’s hard to see if that’s been cut too short.
But…. Main point is that raw edges don’t line up, stitching lines do. So, with a half inch seam allowance, those pattern pieces should actually overlap by 1″.
Try that and see how they fit.

I’m just understanding it wrong, I think.

My fabrics are too dark to photograph clearly so I’ve attached a photo of the paper pattern pieces. I’ve laid out the pieces for the facing and lining right side up, aligned at the notch. My understanding is the outside curve of the back facing attaches to the inside curve of the lining neck, right…[Read more]

Hi Anne, do you have notches or pattern markings present but not lining up?
If the markings are all present then you might have the wrong size, or an error somewhere.
If there’s no markings to line up then I’m guessing you’re trying to attach the facing upside down.

Check your pattern pieces, then check you’ve transferred all the markings…[Read more]

Thank you Shelley, I really appreciate the help. I’m very hopeful I’ll get this cut out correctly. Maybe not tonight though!? Cutting too late at night likely added to my issues. 😉

Your Woodland Stroll is beautiful by the way.

Image

My reply disappeared…

In that case use the button markings and edge of buttonholes to create a vertical line that you’ll then match your pattern to.

Don’t forget that the buttons sit to the edge of the buttonhole, not the centre.

I’ll try and attach a picture without losing the reply again 🙂

Sorry Shelley, I didn’t answer your question. Yes, I would like the plaid to match up (perfectly haha) when the cape is buttoned.

Hmmm. I just went back and checked the pattern (one I printed and taped together, and I’m not seeing a center notch for the front piece. There is one on the back piece!

Thank you Shelley! That makes perfect sense. I even used tracing paper, I probably just didn’t transfer that marking – making it it extra difficult for myself. My husband voted to leave it as it is, but I think I can manage to cut the pieces again.

Schooling my young children at home and helping (and worrying about) a sick furry family member h…[Read more]

Do you want it to match when it’s buttoned closed?

You need to mark the centre front on each pattern piece as a vertical line. I think there’s a notch at the neck line to indicate where this is from memory.
Then, when you cut, you make sure the centre front lines hit the same part of the plaid pattern, not the edge of the pattern piece.

If you…[Read more]

Figured out what the problem was, I increased the yoke size in height at the shoulder but did not increase the neckline so thought the collar portion would be ok, it wasn’t. Had to recut the yoke, works fine now. Thank you for your help.

Hi Debra,
Can you post a photo as that might help spot where the problem is.
Here’s how I troubleshoot this kind of problem:
1: notches missing or not matching at all?
– I’m trying to attach something upside down
2: centre back and shoulder notches good, one front ok, but all the length missing on the other side?
– I’ve mucked up one placket…[Read more]