Cutting piece 1 in size 2T

Viewing 3 posts - 1 through 3 (of 3 total)
  • 15 years ago LINK
    Sarvi @Sarvi

    While tracing this pattern I found that the top of the curve seems incomplete (above and the the left of the fold). I see where I have to cut the little pad of interfacing and can estimate where the curve above it should be, but am I just not seeing the line I should be following? Thanks for any help!

    15 years ago LINK
    Liesl Gibson
    Keymaster
    @liesl

    Hi Sarvi,

    I think that line did get cut off for one printing of the pattern, so that might be the copy you have. Fortunately, you can use the lining/facing piece to get the same curve. Sorry about that! Holler if you have additional questions.

    15 years ago LINK
    Sarvi @Sarvi

    Ok, that’ll work fine. Just wanted to check since I’m pretty inexperienced. Thanks!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

copyright

Unless otherwise credited, all work on this blog is © Liesl + Co., Inc, 2008-2024. You are welcome to link to this blog, but please ask permission before using any text or images.