I just printed out my first O+S digital pattern. The 1" square measured correctly. I followed the directions which stated "if a piece bleeds over the gridded area, trim the edge from the piece so that only the grid remains. Join the piece...using the grid lines to align the pieces."
I did this and on a couple pieces I ended up having my edges missing, and on other pieces having to align my pieces using the actual pattern lines because matching the grid lines caused the pattern lines to be completely off.
Does anyone have any ideas what may have happened? All of the grid squares do equal 1". Will my pattern be the right dimensions if I lined things up by the pattern lines instead of the grid lines?
Thanks