I'm curious if anyone else has tried this for the Music Box Dress? I did it and it turned out "okay", but my measurements were not quite what I thought they should have been. I mean, I think I had the measurement correct the first time, then when I sewed the inverted pleat/gore back onto the front panels, it didn't seem to be the same width across the entire front piece, so I unpicked and trimmed a bit off the pleat piece. However, I think I trimmed too much. Thus, when I sewed them back together for the 2nd time I just used a narrower seam allowance, and all seemed fine. That is until I was pinning the yoke to the skirt and the yoke was a tad wider in the center section which caused me to do quite a bit of easing (to my dismay). Now I'm wondering if I had it right to begin with?!?!!!
Liesl or anyone else, what measurement would you use to cut a center box pleat/gore piece (how wide of a strip) and what seam allowance would you use to attach it to the front panels (which have also been cut/trimmed down and are no longer one piece on a fold).
Hope this is as clear as mud.